CONELOG® SURGICAL PROCEDURES - Camlog

ACCESSORIES
CONELOG ® ADAPTER FOR NARROW GAPS AND
HOLDING SLEEVE FOR SCREW IMPLANTS TO GUIDE
THE ADAPTER INTO THE IMPLANT
Two special reduced-diameter CONELOG ® adapters (long) are available for
CONELOG ® SCREW-LINE implant diameters Ø 3.3 mm and 3.8/4.3 mm to
assist manual insertion into small gaps. Three lateral marks match the cams
on the adapter, thus providing a buccal orientation for one of the CONELOG ®
SCREW-LINE implant grooves. After removing from the primary package
(blister), the color-coded holding sleeve with the correct diameter is inserted
over the endosseous part of the implant to guide the adapter into
the screw implant. The sleeve is squeezed together like a collet at the level
of the implant shoulder, and the handle is removed.
NOTE
We recommend using a hemostatic clip to squeeze the sleeve together
to hold the implant securely and tightly in the sleeve. The handle can
then be removed, the retention screw of the insertion post loosened
with a screwdriver, hex, and the insertion post removed.
IMPORTANT NOTE
The CONELOG ® adapter and the holding sleeve must be sterilized before
use.
Setting up the
sleeve
Squeezing together sleeve with a
hemostatic clip and removing handle
Unscrewing the
retention screw
CONELOG ® SCREW-LINE IMPLANT
CONELOG ® adapter, long,
for Ø 3.3 mm and Ø 3.8/4.3 mm
Holding sleeve for screw implants, Ø 3.3 mm,
Ø 3.8 mm and Ø 4.3mm
Removing the CONELOG ®
insertion post
51