Progress Sonic ESB Configuration and Management Guide

◆ To make logging and tracing for an ESB Container permanent:
Logging and Tracing
1. On the Configure tab in the Sonic Management Console, select the management
container that hosts the ESB Container on which you want to maintain logging and
tracing.
2. In the right panel, right-click on the ESB Container,and then select Properties.
3. In the Edit Container Component Properties dialog box, enter the sum of the integer
values for each tracing bit you want to set, as specified in the Edit Sonic ESB
Container Properties dialog box.
In this example, Verbose (1), Set Attributes (2), and Enable Debug Messages(16) are
intended so the sum of 1+2+16, 19 is entered as the Tracing Mask value as shown:
These tracing bits are set in the runtime whenever this container starts.
4. Click OK to apply the setting. The changed value is immediately applied to the
runtime settings.
Note Tracing options are also available on the management container as temporary runtime
overrides and standard settings that are re-established when the management container
restarts.
Progress Sonic ESB Configuration and Management Guide 8.5 86