kopie - copia - cópia - Operator's Manual - John Deere
kopie - copia - cópia - Operator's Manual - John Deere
kopie - copia - cópia - Operator's Manual - John Deere
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Adjusting the cutting height (Illustration I )<br />
Safety instruction!<br />
See table for explanation of symbols page 3<br />
– The cutting height is set on the left hand side of the lawnmower<br />
– Press the button with your thumb (1) and move the handle of the lawnmower into the required position by moving it up<br />
or down (2).<br />
– By letting go of the button, the lever locks into the required cutting height.<br />
– The marking on the left of the housing indicates the cutting height.<br />
IMPORTANT<br />
Mowing at the lowest cutting height should only be carried out on level and plane lawns!<br />
Please observe that the lower cutting height settings may only be used for optimal conditions. If you select cutting<br />
height that is too low, the turf can be damaged and under certain circumstances it can even be destroyed.<br />
Besides the cutting height, also the moving speed influences the cutting pattern and collection result. Adapt the<br />
cutting height and moving speed to the grass height to be cut.<br />
8 BEFORE USING THE LAWNMOWER FOR THE FIRST TIME<br />
Safety instruction!<br />
See table for explanation of symbols page 3<br />
Check that all connections and the spark plug connector are fitted firmly. Tighten the screws if necessary! In particular make<br />
sure that the cutter bar is fitted correctly (see Chapter “Maintenance of the blade”).<br />
The blade attachment screw should always be fitted and tightened by a specialist workshop. If the blade attachment screw is<br />
too tight or too loose, the blade clutch and blade can be damaged or become detached, which can cause severe injury.<br />
Make sure that all safety devices are fitted properly and are not damaged.<br />
Filling with oil (Illustration Y1 )<br />
Safety instruction!<br />
See table for explanation of symbols page 3<br />
IMPORTANT<br />
Avoid damage! Engine is delivered without oil.You must add oil before running the engine.<br />
Before starting the mower the first time fill motor oil (for quantity and type, see technical data) into this opening with a funnel<br />
after unscrewing the dipstick.<br />
– Park mower on a level surface.<br />
– Pour in oil slowly into the oil filler. Do not pour in too much oil.<br />
– Check the oil level.<br />
Remove the dipstick. Wipe the dipstick with a clean cloth, insert the dipstick into oil filler without screwing it in Then<br />
remove the dipstick once again and read off the oil level. The oil must be between the marks "ADD" and "FULL". Add oil<br />
if necessary. However the oil level should not be above "FULL" mark.<br />
Replace oil dipstick and retighten.<br />
– After filling up for the first time remove the “NO OIL” sign on top of the engine.<br />
Filling with fuel<br />
– Only fill the tank with fresh and clean unleaded standard petrol.<br />
Fuel with up to 10% ethanol is acceptable.<br />
– The petrol tap should be kept closed Y2 !<br />
– Unscrew tank cap.<br />
– Fill tank with fuel using a funnel up to max. lower edge of filling nozzle.<br />
– Replace tank cap and screw tight.<br />
9<br />
Safety instruction!<br />
See table for explanation of symbols page 3<br />
GB