kopie - copia - cópia - Operator's Manual - John Deere
kopie - copia - cópia - Operator's Manual - John Deere
kopie - copia - cópia - Operator's Manual - John Deere
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
GB<br />
9 STARTING THE ENGINE (Illustration S2 + C + E )<br />
Only start the engine when standing behind of the mower.<br />
– Open the fuel cock S2 .<br />
– When the engine is cold, push the actuation lever (1) into the position I/I" (Choke) (2) C .<br />
– Slowly pull the starter cable (4) until resistance is felt, then rapidly pull it out E , – the engine begins to run, slowly recoil<br />
the cable.<br />
– Under certain circumstances the starting process must be repeated.<br />
– As soon as the engine has started running, put the actuation lever (1) on position "Hot start/operation" (3) C .<br />
– Once the engine is warm, push the actuation lever to position "Hot start/operation" (3) and as described above, start the<br />
engine.<br />
– If the engine does not start running, then proceed as when starting a cold engine.<br />
– In the position "Hot start/operation" the engine runs at maximum power and maximum speed which is required for a<br />
clean cutting pattern (engine speed = blade speed).<br />
10 SWITCHING ON THE CUTTING DECK (Illustration H3 )<br />
Safety instruction!<br />
See table for explanation of symbols page 3<br />
Only switch on the cutting deck when standing behind the mower.<br />
Place the mower on a level surface where the grass is not too high (high grass inhibits the start of the cutter bar and makes<br />
starting more difficult). Where this is not possible, position the mower in such a way that the cutter is facing diagonally away<br />
from the user, although only as far as absolutely necessary.<br />
– Press and hold down the safety control bracket (1) against the upper section of the handlebar.<br />
– Push the lever (2) quickly forward as far as the stop, and then release. The lever returns automatically to its starting<br />
position.<br />
IMPORTANT<br />
Switching on the cutting deck slowly will lead to excessive wear to the brake and clutch fittings and overheating of<br />
the complete brake clutch system.<br />
For trouble-free operation of the starting system, the cutting deck must be started according to the sequence<br />
specified above.<br />
11 SWITCHING OFF THE CUTTING DECK (Illustration I3 )<br />
– Quickly release the safety switch bar for the blade brake.<br />
IMPORTANT<br />
As soon as the safety control bracket is released, it springs back to its starting position under spring pressure, the<br />
blade brake now comes into operation, and the blade is brought to a standstill within 3 seconds.<br />
12 SWITCHING OFF THE ENGINE (Illustration I3 + G3 + Y2 )<br />
– Quickly release the safety switch bar for the blade brake I3 .<br />
– Move the operating lever to the STOP position G3 .<br />
– Close the petrol tap Y2 .<br />
13 EMERGENCY STOPPING<br />
ATTENTION<br />
Avoid injury! The blade must stop within 3 seconds. If not, please contact the nearest authorized dealer.<br />
Release the safety control lever and the drive switch bar.<br />
– The mower will stop.<br />
– The blade will stop.<br />
10