Strata DK 16 Manual

INSTALLATION-WIRING DIAGRAMS
SECTION lOO-816-208
MARCH1993
DB-25 RS-232 NOTE 1: If connected to external modem, interchange pin 2 and pin 3,
and pin 20 and 8. Send AT&Cl command to external modem
rack status of carrier detecf signal.
PDIU-DS,
TO ASCII
TO PRINTER
l 8-BIT
. NO-PARITY
l l-STOP BIT
1
TOSHIBA W-23
NOTE 3: PIOUS option settings:
SW1 - Sets the SMDR baud rate
to be 300 or 1200 BPS.
S W2 - Sets the PlOlJ programming speed to be
300 or 1200 BPS (for IMDU or TTY jack).
LED CO4 “On” = 300 BPS/SW2 set “In”.
LED CO4 “Ow’= 1200 BPS/SW2 set “Out”.
SW3 - Sets the PIOUS to operate with the
IMDlJ or an external device
connected
~~_
MODEM
to the l7Y modular jack.
- For IMDU operation (7, even, 1)
-l-l-Y - For ASCII terminal (8, none, 1)
or external modem (8, none, 1).
W4 - Sets the IMDU and TTY jack
for bell or CC177 specification.
BELL - “W4 not installed”.
NOTE 4: PDIlJ-DS jumpers should be set to
the B-C position when connected
to the PIOUS TTY or SMDR port.
FIGURE 8-24
DK16 PIOUS/TTY AND SMDR WIRING
TE 2: Wire colors may vary with other
types of modular adaptors.
8-28
PIOUS
MAINTENANCE CARD i
PORT
-,,,/- SMSG
rr SMCD 6
-SMDTR-
- .shrln.sR -
1
3
D
STATION MESSAGE
DETAIL RECORDING
PORT
NOTE: 600 ohm Page
is not funcfior,,, ,r\
on DK16
I I
PIOU MODULAR PIN-OUT
PIN NO.1 l-’ ’
6 TYSG 1 SMSG
PPTC PIN-OUT
/
1
1 I I,1 cc
-
l-l-Y
(IMDU)
(6-PIN
MODULAR
JACK)
I OHM
GE
““1 ( F ALARM
IOR LOCK,’
IP, MUTE