Strata DK 16 Manual

PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 100-816-302
MARCH 1993
PROGRAM 39
FLEXIBLE BUTTON ASSIGNMENT REFERENCE GUIDE
\larm
411 Call
loice Page
4utomatic
3usy Redial
4utomatic
:allback Bus\
3ackground
Vlusic
~-~~~~-~~~~-~-~~~~-~-~
Alarm Reset
or ALRM
All Call Page
or AC
Auto Busy Redial
SELECT = Port Number
Code: 1
or range. See Note 4. Press LED/button T
to be defined. See tables
Enter the appropriate code that corresponds
to the feature to be assigned. See the
on the following pages. feature code reference table below.
77
89
Resets alarm
condition system wide
Pages all idle electronic/digital
telephones over speaker
Sets ABR of busy outgoing
number
Sets ACB for station
recalled by busy line
Turns BGM ON or OFF
through station speaker
>all Forward Call Frwd All Calls 87 All calls forward to selected
411 Calls or CFAC
station
3all Forward
4.C. Fixed
Zall Forward
3usy
Zall Forward
3usylNo
4nswer
Call Frwd to:
or CFF
Call Frwd Busy
or CFB
Call Ftwd Busy/
NAns
or CFBINA
86
5g
57
Forwards all calls to pre-defined
destination. See Prog. 36
Forwards calls to selected
station if station is busy
Forwards calls to selected
station if station is busy or
does not answer
Zall Forward
No Answer
Call Frwd
No Answer
or CFNA I
Forwards calls to selected
58
r
station if station does not answer
I
Picks up ringing or held intercom.
Call Pickup
Tenant 1 1 rn”r’
83
Picks up tenant 1
ringing CO calls
Call Pickup
Tenant 2
CO Line
Appearance
PKUPP 82
Line 01 - 08
or CO 01 -
CO 08
1 - 08
Picks up tenant 2
rinaina CO calls
CO line access of
appearing calls
30 Not
Do Not Disturb g8
Prevents calls to station
3isturb I or DND I I
Door Lock 0
Unlock Door 0
or DRLK 0
I
7, Momentarily unlocks door
(3 or 6 sec.) PIOUS/PIOU
Privacy Release
Redial Last
Number (# key)
Release
NOTES:
1. For more information, see instructions preceding record sheets.
2. Complete Program 38 before Program 39.
3. initialized data assigns the keystrip pattern associated wfth Gode 31 worn Program 38.
4. Specify a range of ports by keying in:
q omnn
Low port-’ L High port
Privacy Release 7g
or PRV RLS
RDL
(EKT only) ”
Release Call
or RLS
76
Momentarily unlocks door
(3 or 6 sec.). See Prog. 77-l
Changes station Privacy
mode to Non-private for CO?
Redials the last
number
Releases current call
and makes station idle
Save Last Save Last Number 85 Saves last number dialed
Number or SAVE for future speed dial
Speed Dial
Select (* key)
II.,
Speed Dial
or SDS
97
Begins speed
selection
dial
5. Flash (FLASH) (MW/FL): Sets pauses in Speed Dial if telephone does not have a pause button. Sets f/ashes in Speed Dial numbers if telephone has a
pause butfon.
6. Redial (MEDIAL or RDL) and Speed Dial (SDS): Both buttons must be programmed on Electronic telephones; not allowed separately. Recommended
on all stations using voice mail, since they allow easy access of * and # DTMF buttons (see note 8 below).
7. Pooled Line Grp (PL): Codes 67 - 68 represent CO line groups 81 - 88. Maximum four Pooled Line Grp (PL) buttons perpooled line group on each
station.
8. Redial is a fixed button on 2000-series Digital Telephones andREDIAL is a fixed button on IOCJO-series Digital telephones. Do not assign button as flexible
button on digital felephones; a/so, Speed Dial (SDS) is initialized on flexible button 20 on Digital telephones.
2-76