SHARP TROUBLE & ERROR CODES AR-651, AR-810 - OlsonBros
SHARP TROUBLE & ERROR CODES AR-651, AR-810 - OlsonBros
SHARP TROUBLE & ERROR CODES AR-651, AR-810 - OlsonBros
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
[E57] Leading edge of paper not reaching the reverse sensor 1<br />
Is there any paper before the registration sensor when the exit cover is opened?<br />
NO<br />
Remove the paper.<br />
Is the reverse sensor 1 working? (Perform the input check in the test mode: 03-[ENERGY<br />
SAVER]OFF/[2]/[B])<br />
YES<br />
1. Check if the connector of the reverse sensor 1 is not disconnected.<br />
2. Check if the connector J335 on the LGC board is not disconnected.<br />
3. Check if the connector pins are not disconnected and the harness is not<br />
open-circuited.<br />
4. Check if the conductor pattern on the LGC board is not short- or open-<br />
circuited.<br />
5. Replace the reverse sensor 1.<br />
6. Replace the LGC board.<br />
Is the reverse motor driving? (Perform the output check in the test mode: 03-126)<br />
YES<br />
1. Check if the connector of the reverse transport unit is not disconnected.<br />
2. Check if the connector J335 on the LGC board is not disconnected.<br />
3. Check if the connector pins are not disconnected and the harness is not<br />
open-circuited.<br />
4. Check if the conductor pattern on the LGC board is not short- or open-<br />
circuited.<br />
5. Replace the LGC board<br />
Is the gate solenoid working? (Perform the output check in the test mode: 03-274)<br />
YES<br />
YES<br />
NO<br />
NO<br />
NO<br />
1. Check if the connector of the gate solenoid is not disconnected.<br />
2. Check if the connector J335 on the LGC board is not disconnected.<br />
3. Check if the connector pins are not disconnected and the harness is not<br />
open-circuited.<br />
4. Check if the conductor pattern on the LGC board is not short- or open-<br />
circuited.<br />
5. Replace the LGC board<br />
1. Check if there is no mechanical loading at the exit/reversal gate.<br />
2. Check the myler at the reverse section and clean it, or if it is deteriorated, replace it.<br />
5 - 29 <strong>AR</strong>-<strong>651</strong>/<strong>810</strong> <strong>TROUBLE</strong> SHOOTING