SHARP TROUBLE & ERROR CODES AR-651, AR-810 - OlsonBros
SHARP TROUBLE & ERROR CODES AR-651, AR-810 - OlsonBros
SHARP TROUBLE & ERROR CODES AR-651, AR-810 - OlsonBros
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
[Procedure 2]<br />
Is second feed motor (M8) rotating in reverse at the fixed timing?<br />
YES<br />
NO<br />
Replace second feed motor or finisher controller PC board.<br />
Is the shutter securely attached to the shutter upper/lower bars?<br />
YES<br />
NO<br />
Attach it securely.<br />
Turn feed roller-2 in reverse by hand. Do the shutter upper/lower bars move up and down?<br />
YES<br />
NO<br />
Fix the mechanism including the shutter upper/lower bars and gears of the feed<br />
roller-2.<br />
Is the shutter open sensor (PI5) working normally?<br />
YES<br />
NO<br />
Replace the sensor.<br />
Replace the finisher controller PC board.<br />
[Procedure 3]<br />
Check the safety zone switch (MS3). Is the switch working normally?<br />
YES<br />
NO<br />
Replace the switch.<br />
Is the safety zone switch (MS3) correctly pressed?<br />
YES<br />
NO<br />
Fix the mechanism.<br />
Is the shutter closed detecting switch (MS4) working normally?<br />
YES<br />
NO<br />
Replace the switch.<br />
Is the shutter closed detecting switch (MS4) correctly pressed?<br />
YES<br />
NO<br />
Fix the mechanism.<br />
Replace the finisher controller PC board.<br />
<strong>AR</strong>-<strong>651</strong>/<strong>810</strong> <strong>TROUBLE</strong> SHOOTING 5 - 80