SHARP TROUBLE & ERROR CODES AR-651, AR-810 - OlsonBros
SHARP TROUBLE & ERROR CODES AR-651, AR-810 - OlsonBros
SHARP TROUBLE & ERROR CODES AR-651, AR-810 - OlsonBros
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
[EA6] Finisher early arrival jam<br />
Is there any paper remaining on the transport path in the finisher or main unit?<br />
NO<br />
YES<br />
Remove the paper.<br />
Is the connector J17 on the finisher controller PC board disconnected?<br />
Is the harness connecting the finisher controller PC board and inlet sensor (PI1) open-circuited?<br />
NO<br />
YES<br />
Connect the connector securely. Replace the harness.<br />
Is the inlet sensor working properly? (Check the movement of the actuator.)<br />
YES<br />
NO<br />
1. Connect the connector of the inlet sensor securely.<br />
2. Attach the actuator securely if its shaft is out of place.<br />
3. Replace the inlet sensor.<br />
Replace the finisher controller PC board.<br />
5 - 43 <strong>AR</strong>-<strong>651</strong>/<strong>810</strong> <strong>TROUBLE</strong> SHOOTING