Edwards IH Instruction Manual - Ideal Vacuum Products

Section Title Page
8 SERVICE, SPARES AND ACCESSORIES 8-1
8.1 Introduction 8-1
8.2 Service 8-1
8.3 Spares 8-1
8.4 Ordering accessories 8-2
8.4.1 Exhaust Temperature Sensor 8-2
8.4.2 Active Gauge Connection Kit 8-2
8.4.3 iH600 Pressure Control Kit 8-2
8.4.4 iH Enclosure Extraction Fan Kit 8-3
8.5 Other accessories 8-3
8.5.1 iTIM 8-3
8.5.2 iM Interface and Communications Modules 8-3
8.5.3 iH Single Pumpset Monitor and iH Fabworks 8-4
8.5.4 iH PC Interface Kits 8-4
8.5.5 iH Alternative Connections Kits 8-4
8.5.6 iH Alternative Exhaust Kit 8-4
8.5.7 iH Nitrogen Flow Switch 8-4
8.5.8 iH Pump Display Module 8-5
8.5.9 iH Pump Display Module Extension Cables 8-5
8.5.10 iH Pump Display Terminal Extension Cables 8-5
8.5.11 iH Disconnect Box 8-5
8.5.12 iH Photohelic Switch/Gauge Kit 8-5
RETURN OF BOC EDWARDS EQUIPMENT
Illustrations
Figure Title Page
1-1 The iH system (iH1000 shown, with side panels removed) 1-7
1-2 Schematic diagram of the HCDP pump gas system 1-9
1-3 Schematic diagram of the iH80/iH600 electrical systems 1-13
1-4 Schematic diagram of the iH1000 electrical system 1-15
1-5 Services and electrical connections on the rear of the iH system 1-17
1-6 Electrical components (shown without enclosure for clarity) 1-19
1-7 Controls and indicators on the dashboard 1-20
1-8 Front panel of the pump display terminal 1-24
1-9 Disconnect box general arrangement 1-26
1-10 Label positions on HCDP and HCMB 1-27
1-11 Label positions on iH system enclosures 1-28
2-1 iH80 dimensions (mm) 2-3
2-2 iH600 dimensions (mm) 2-4
2-3 iH1000 dimensions (mm) 2-5
2-4 Services connections dimensions (mm) 2-6
iH Dry Pumping Systems
v