INT1100 User Guide - Mitel Edocs
INT1100 User Guide - Mitel Edocs
INT1100 User Guide - Mitel Edocs
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
C. Connect the base unit<br />
1) Connect the AC adapter to the DC IN 9V<br />
jack and to a standard 120V AC wall<br />
outlet.<br />
2) Set the base and charger (for TRU5860-2<br />
only) on a desk or tabletop, and place the<br />
handset in the base unit as shown.<br />
GETTING STARTED<br />
3) Make sure the status LED illuminates. If the LED does not<br />
illuminate, check to see that the AC adapter is plugged in<br />
and that the handset makes good contact with the base<br />
charging contacts.<br />
• Use only the supplied AD-312 AC adapter.<br />
Do not use any other AC adapter.<br />
• Connect the AC adapter to a continuous power supply.<br />
• Place the base unit close to the AC outlet so that you can unplug<br />
the AC adapter easily.<br />
4) After installing the battery pack in the handset,<br />
charge your handset at least 15-20 hours before<br />
plugging into the phone line.<br />
5) Once the handset battery pack is fully charged,<br />
connect the telephone line cord to the TEL LINE<br />
jack and to a telephone outlet.<br />
If your telephone outlet isn't modular<br />
type, contact your telephone company<br />
for assistance.<br />
Modular<br />
Place the power cord so<br />
that it does not create<br />
a trip hazard or where it<br />
could become chafed<br />
and create a fire or<br />
electrical hazard.<br />
GETTING STARTED<br />
[ 11 ]