INT1100 User Guide - Mitel Edocs

Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base
unit. Normally, setting the code is not necessary. In the rare situation that you suspect
another cordless telephone is using the same security code, you can change the code. To
change the digital security code, de-register the code, then register a different code.
De-register the Digital Security Code
1) Remove the handset from the base. In the standby mode, press and hold xfer/del and
end for 10 seconds. You will hear a confirmation tone. “De-Register?” appears.
2) Press + to select “Yes”, then select/ch. You will hear a confirmation tone, and
“Deregistration Complete” appears.
You will need to reregister
the additional
handset each time you
change the digital
security code of the
original unit.
• If you have not pressed any key for 30 seconds while in the de-registering operation, the
phone returns to the standby mode.
• While in the de-registering operation, if you receive an incoming call, page, or transferring call,
or charge the handset, or press talk/flash, spkr or end, the operation is canceled.
ADDITIONAL
INFORMATION
ADDITIONAL INFORMATION
[ 37 ]