NewTom VG User Manual rev 4.0 - Image Works
NewTom VG User Manual rev 4.0 - Image Works
NewTom VG User Manual rev 4.0 - Image Works
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
About safety<br />
Local laws<br />
Carefully follow every requirements about installation and maintenance of the device. Please refer to the<br />
local laws whenever these may be more strict than the instructions inside this manual.<br />
Switching on and off of the device<br />
Turning the device on and off must be performed according to the procedures described inside this manual<br />
(see 2.2 "Turning the device off" and 4.8 "System startup").<br />
Emergency stop<br />
In case of an emergency, follow the instructions referring to the device emergency stop, see 2.3 "Emergency<br />
shutdown".<br />
Maintenance time lag<br />
Please be sure that the maintenance controls that are described in 3.4 "Device maintenance" are performed.<br />
During patient positioning<br />
Before activating the positioning laser always warn the patient to close his/her eyes.<br />
While scanning a patient<br />
NEVER leave the system without a supervisor during the execution of an exam. Always watch the patient all<br />
along the scan process.<br />
Artifacts<br />
Please contemplate the repeating of a scan ONLY if suspect or significant artifact are evident in a patient's<br />
images, or if a patient's position appreciably changed during the exam.<br />
WARNING:<br />
Every operator must have a deep knowledge of the system operative and<br />
environmental features, he/she also must know the procedures to follow in<br />
case of emergency.<br />
WARNING:<br />
Never use the device without the supervision of an operator.<br />
NOTE:<br />
Please consider the realization of an audio/video communication system between the<br />
operator and the patient, especially when the operator controls the device from a<br />
protected and remote location.<br />
2.2 Turning the device off<br />
Hereafter the procedure for a proper turning off of the device is described:<br />
1. Close the software.<br />
2. Shutdown the operating system.<br />
3. Wait for the workstation power off.<br />
4. Turn the unit off by mean of the main switch, which is situated on the Control Box.<br />
Rev. 1.0 - 02/15/2009 Page 8 of 72