Intel® NetStructure™ 6000 Switch

C H A P T E R 3
Intel® NetStructure 6000 Switch User Guide
To configure RIP
1 Click the Routing menu, then RIP Configuration. The RIP
Interfaces screen is displayed.
2 In the Protocol Preference box, type the preference. The range
is from zero to 255. The default is 100.
3 In the Metric box, type the Metric. The range is from zero to 16.
Each RIP routing table entry contains a metric or cost for each
destination, called a hop. RIP selects the route with the lowest
hop count as the best route. However, the longest hop cannot
exceed 15 hops.
4 Click Submit.
5 Click Apply Changes in the Configuration Status table. The
changes apply to the current session only.
6 In the Add RIP Interface box, select an IP address from the list.
7 Click Add.
106