Intel® NetStructure™ 6000 Switch

A P P E N D I X A
Command Reference
show link { port_number | all }
displays the basic media configuration for the port number
designated by port_number or for all ports.
Example
6000 Switch>#>show link 18
Port 18 (10/100) Autonegotiation is enabled. Speed=10Mb Duplex=half. Link is UP.
Link Partner NOT autoneg capable
Local Advert: 100BX Full Duplex | 100BX | 10 BT Full Duplex | 10BT
6000 Switch>#>show link 1
Port 1 (Switched Gbe) Autonegotiation is enabled. Link is UP.
Local Advert: No tx flow control. Obeys flow control. Duplex=full.
Remote Advert: No tx flow control. Does NOT obey flow control.
Duplex=full.
show link agg { port_number | all }
displays the current state of the port link specified by all for all
ports or a selected port number designated by port_number.
This command is available in both privileged and nonprivileged
mode. These are the configuration parameters that
are stored in NVRAM via the set link command. The table of
aggregator parameters is displayed followed by the table of
media port parameters.
Example
6000 Switch>#>show link agg 4
----------------- Aggregator 802.3ad Configuration -------------------------------
Admin-
GP SPri System ID Name
State AKey
4 8000 00:40:2F:02:24:01 Agport_28 up 001C
Field definitions (not included in command line display)
Show
Field
802.3ad MIB
set
link
option
Description
GP n/a n/a Global port number (starts at 1
and counts through installed
ports only).
SPri AggActorSystemPriority (no) System priority (16 bit hex).
System
ID
AggActorSystemID (no) System ID for the local system in
MAC address format.
Name AggName (no) ASCII name for aggregator (15
chars)
Admin
State
AggAdminState
up,
down
“Up” allows aggregation,
“down” disables aggregation.
AKey AggActorAdminKey akey Key for the aggregator (16 bit
hex)
286