Intel® NetStructure™ 6000 Switch

C H A P T E R 4
Using Local Management
The following commands accept host names (in addition to IP
addresses) as arguments: arp, loadnv, netstat, ping, route, savenv,
sn
Before running the enable dns command you need:
1 To set the IP address of the primary DNS server. Type the privileged
set dns primary ip_address command.
6000 Switch>#>set dns primary 192.2.2.150
2 Type the privileged set backup dns ip_address command to set
the backup DNS server.
3 Type set dns domain domain_name to set the DNS default
domain.
6000 Switch>#>set dns domain xyz.com
Note The switch supports a default domain name of up to 64
characters.
4 Type enable dns to activate the use of the DNS.
6000 Switch>#>enable dns
Note The enable dns command fails if the primary DNS server
has not been set.
5 Type the set dns primary command without the IP address of
the server to clear the DNS primary server.
Note Clearing the DNS primary server automatically disables
DNS.
6 Type show dns to display the current DNS settings.
Refer to Appendix A for additional DNS commands.
141