Intel® NetStructure™ 6000 Switch

C H A P T E R 1
Using the Switch
Power Supply Replacement
A loss or reduction of power causes a full or partial shutdown of the
switch.
Type the show sysfails command at the terminal to determine which
of the power supplies has failed.
Type the non-privileged command clear sysfails after replacing a
power supply to reset the show sysfails command.
6000 Switch>#>clear sysfails
The system failure area has been cleared.
Caution
If the switch has two power supplies, place the replacement
in the empty power-supply bay before removing
one of the power supplies. This prevents the switch
from powering down during hot swap of the power supplies.
Power Supply
Capture Panel
To replace a power supply
1 Loosen the capture panel screws on the front of the power supply.
2 Using the handle, pull out the power supply with one hand and
27