Intel® NetStructure™ 6000 Switch

C H A P T E R 4
Intel® NetStructure 6000 Switch User Guide
Diagnostics
During power up, the switch runs the ROM Resident Startup
Diagnostics Report.
ROM> ===== 6000 Switch ROM Resident DIAGNOSTICS/STARTUP =====
ROM> Waiting for Carrier Ready: OK
ROM> Processor checks
ROM> LED/ID/JUMPER checks
ROM> + CP ID: A
ROM> + JUMPERS: 000000D
ROM> LED Display checks
ROM> RS232 UART checks
!"#$%&’()*+,-./0123456789:;?@ABCDEFGHIJKLMNOPQRSTU-
VWXYZ[\]^_‘abcdefghijklmnopqrstuvwxyz{|}~
ROM> Capella Register checks
ROM> Size Memory = 01000000
ROM> Bypassing DRAM checks
ROM> Copy ’Boot-Image’ from ROM --> DRAM: OK
ROM> Verify ’Boot-Image’: OK
ROM> Watchdog/Timer checks
ROM> PCI 82558 & IPC/PBM checks
ROM> + i82558 CSR Map range: 0F800000 -> 0F801000
ROM> + Detected 82558 MAC Address: 00:40:2f:00:90:00
ROM> + IPC/PBM Map range: 00000000 -> 00100000
ROM> Bypassing Packet Buffer checks
ROM> DMA transfer checks
ROM> Copy Load-Image from ROM --> DRAM Hi-memory: OK
ROM> Verify Load-Image: OK
ROM> Waiting for Carrier Lock: OK
ROM> Validate RELEASE image: OK
ROM> Copy ’Release-Image’ from NAND --> DRAM: OK
ROM> Verify ’Release-Image’: OK
ROM> Released Carrier Lock
ROM> Jump to Release-Image ’C’ BOOT-CODE in DRAM
Initializing Powerup Diagnostics...
Powerup BIST Diagnostics are running:..........................
Powerup BIST Diagnostics Passed
6000 Switch Console
BOOTED: Mon 6/7/99 13:00
PASSWORD:
Note
The switch displays an error message if it detects any errors,
or failed components during the power up routine.
Boot Image Mode
The switch uses the boot image when the system image check has
failed or become corrupted. The following message is displayed
during Power Up Diagnostics:
Jump to Boot-Image ’C’ BOOT-CODE in DRAM
During normal boot up the command line reads:
Jump to Release-Image ’C’ BOOT-CODE in DRAM
142