User Manual XXL Globetrotter 2006 - Dethleffs

Before the journey
4
4.5 Entrance step
Before commencing the journey and after short interruptions of the
journey, ensure that the entrance step is completely retracted.
Do not stand in the direct range of the entrance step while it is being
retracted or extended.
Do not step on the entrance step until it has extended completely. There
is a risk of injury.
Do not under any circumstances raise or lower persons or loads with the
entrance step.
Take note of the different step heights and make certain that the ground is
firm and even when exiting.
Do not grease or lubricate the pivot bearing and joints of the entrance step
(see chapter 12).
The switch to operate the entrance step is located on the inside of the
vehicle in the area of the conversion door.
If the entrance step has not been properly retracted and locked into place,
a warning tone is heard when the ignition is switched on.
Follow the warning notice on the entrance step.
Fig. 1
Warning notice for entrance
step
Fig. 2
Operating switch entrance step
Before stepping on the entrance step, fully extend it (Fig. 1).
Extending:
Retracting:
Press the rocker switch (Fig. 2,1) down until the entrance step has
extended completely.
Press the rocker switch (Fig. 2,1) up until the entrance step has retracted
completely.
The entrance step can also be retracted and extended with the remote control.
Globetrotter XXL - 05-06 - DET-0047-00EN
33