User Manual XXL Globetrotter 2006 - Dethleffs

10
Appliances
10.2 Alde hot-water heater
Never let gas escape unburned due to danger of explosion.
When filling the fuel tank, on ferries or in the garage, never run the
heater in gas operation. Danger of explosion!
Never run hot-water heater without heating fluid. Observe notes in
chapter 13.
Never drill holes in the floor. This might damage the hot-water pipes.
Do not use the space above and behind the heater as a storage compart-
ment.
Dethleffs recommends to bleed the heating system after the initial heater
operation and to check the glycol content. Observe notes in chapter 13.
For further information, see the separate instruction manual "Alde Compact"
and observe the maintenance instructions found in chapter 13.
For further information about the use of the boiler see section "Boiler".
Initial start-up
When lighting the heater for the first time a small amount of smoke and odour
will occur. Immediately set the operating switch of the heater to its highest
position. Open doors and windows and ventilate well. Smoke and odour will
disappear by themselves after a while.
The hot-water heater has been fitted below in the wardrobe.
1 Sliding switch for 240 V electrical
operation
2 Red indicator lamp "Fault"
3 Sliding switch for gas operation
4 Operating mode "Heater"
5 Operating mode "Heater and hot
water"
6 Sliding switch for circulating pump
7 Operating mode "Hot water"
8 Temperature control knob
Fig. 59
Operating unit for hot-water
heater
Operating modes
Selecting operating mode:
The hot-water heater has three operating modes:
Hot water (Fig. 59,7)
Heater and hot water (Fig. 59,5)
Heater (Fig. 59,4)
Use the sliding switch (Fig. 59,6) to set the operating mode.
The hot-water heater can be operated with the following energy sources:
Gas operation (Fig. 59,3)
240 V electrical operation (Fig. 59,1)
Gas and 240 V electrical operation
86 Globetrotter XXL - 05-06 - DET-0047-00EN