User Manual XXL Globetrotter 2006 - Dethleffs

8
Gas system
Pull out the slide (Fig. 43,1) as far as possible.
Close the regulator tap (Fig. 44,4) on the gas bottle. Pay attention to the
direction of the arrow.
Unscrew the gas pressure regulator (Fig. 44,2) from the gas bottle at the
hexagon nut (Fig. 44,3).
Remove the gas pressure regulator and the gas tube (Fig. 44,1) from the
gas bottle.
Release fixing belt and remove gas bottle.
Place a filled gas bottle in the gas bottle compartment.
Fix gas bottle in place with the fixing belt.
Position the gas pressure regulator (Fig. 44,2) and the gas tube (Fig. 44,1)
on the gas bottle and screw in tightly to the gas bottle at the hexagonal nut
(Fig. 44,3).
Push in the slide (Fig. 43,1) as far as possible, and set the handle
(Fig. 43,2) in a vertical position.
Fold guard plate (Fig. 43,3) up.
Close the external flap (see section 7.2).
8.5 Gas isolator taps
1 Refrigerator
2 Cooker
3 Heater/boiler
4 Oven
Fig. 45
Symbols for the gas isolator
taps
A gas isolator tap (Fig. 45) for every gas device is built into the vehicle.
The gas isolator taps can be found on the front of the cooker.
8.6 External gas connection
If the external gas connection is not in use, always close the gas isolator
tap.
Only gas appliances with a suitable adapter should be connected to the
external gas connection.
Connect only external gas appliances which are designed for an operation
pressure of 30 mbar.
Once you have made the connection and opened the gas isolator tap,
make sure that no gas is escaping at the connection point. If there is a
leak in the external gas connection, gas will escape into the open air.
Immediately close the gas isolator tap and the regulator tap on the gas
bottle. Have the external gas connection checked by an authorised specialist
workshop.
64 Globetrotter XXL - 05-06 - DET-0047-00EN