2008 Manual of Motorcycle Sport - Motorcycling Australia

property of Formula Xtreme Pty Ltd and
can not be used, copied or altered with
out the prior written permission of Formula
Xtreme Pty Ltd.
15.10 NakedBike nk1
15..0.1 This category may allow the mixing of
parts from different models and years of
machines, but caution is advised.
15.10.0.2 Subject to the required and permitted
alterations set out below, NakedBike
machines must:
a) Appear on the homologation
lists available from the Formula
Xtreme Pty. Ltd. The NakedBike
homologation list may be added to
at any time at the discretion of the
Formula Xtreme Pty. Ltd.
b) Be fitted with original ADR
compliance plates for the particular
machine,
c) Have a 4-stoke engine of 2, 3 or 4
cylinders,
d) Have an engine capacity of 590cc or
over.
15.10.0.3 If a particular modification or change of
part is not covered in these rules, then
the modification or change of part is not
permitted.
15.10.1 Definitions- NakedBikes
15.10.1.1 For the purposes of these Rules:
a) OEM means Original Equipment
Manufacture- but not year or model
specific,
b) OEM, per Model means- Original
Equipment Manufacture- but not
year specific,
c) OEM, per Model and Year means
Original Equipment Manufacture- for
the machine’s specific year and model.
15.10.2 Naked Bike - Frames and Parts
15.10.2.1 The following must be removed:
a) Headlamp,
b) Tail lamp and reflectors,
c) Pillion pegs,
d) Horn(s),
e) Traffic indicators,
f) Mirrors,
g) Centre and side stand(s),
h) Registration plate and label holder.
15.10.2.2 The following may be removed:
a) Rear mudguards,
b) Inner guards,
c) Thermo fans,
d) Anti-pollution equipment and/or de
icing gear,
e) Starter motor,
f) Alternator,
g) Any other part or item that will
not affect the safety or structural
integrity of the motorcycle, unless in
contravention of these Rules.
15.10.2.3 Airboxes,
a) Can be removed,
b) If fitted, must have a closed breather
system fitted and operational,
c) May not be ducted other than OEM
per model,
d) May not be pressurised unless OEM
per model and year.
15.10.2.4 Any sharp edges left by the removal of the
above components must be protected by
a rolled edge or beading of minimum 3mm
diameter.
15.10.2.5 Frame as OEM for model and year, but
repairs and bracing are allowed,
15.10.2.6 Sub-Frame(s) - Original profile must be
maintained if repaired or replaced.
15.10.2.7 The following must be as OEM, per model
and year:
a) Swingarm, but alterations permitted,
b) Brake discs,
c) Brake calipers,
15.10.2.8 Any modifications to the frame, sub-frame
or swingarm must not compromise or
undermine the structural integrity of the
machine.
15.10.2.9 The following must be as OEM, per
model:
a) Fork tubes and sliders, but internals
can be altered and external adjusters
can be fitted.
15.10.2.10 The following may be modified as
follows:
a) Rear suspension:
i) Ride height adjuster can be fitted,
ii) Shock absorber manufacturer and
length free,
iii) Link arm rods free,
iv) Rear suspension link free.
15 ROAD RACING
2008 MANUAL OF MOTORCYCLE SPORT enjoy the ride
119