RT120Q Operator's Manual - Ditch Witch
RT120Q Operator's Manual - Ditch Witch
RT120Q Operator's Manual - Ditch Witch
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>RT120Q</strong> Operator’s <strong>Manual</strong> Saw - 133<br />
Normal Use<br />
IMPORTANT:<br />
• Saw use is not recommended for soft, wet, or sticky soil conditions.<br />
• Before operating saw, check bits for free rotation. Tap bits lightly with a hammer and turn<br />
by hand. If bits are stuck, remove and clean packed soil from bit block.<br />
• For best results, use retaining clip loading and removing tool and a knock-out bar included<br />
with saw to remove and reinsert bits.<br />
• Carbide bits are recommended for cutting abrasive material, such as sandstone or frozen<br />
sands or gravels.<br />
1. Fasten and adjust seat belt.<br />
2. Start tractor. See page 76 for start-up procedures.<br />
3. Drive to starting point. Move in line with planned trench. See page 78 for correct operating procedures.<br />
4. Engage parking brake and verify parking brake indicator is on.<br />
5. Move gearbox control to 1 (low).<br />
6. Tilt steering wheel column up.<br />
7. Swivel seat to the desired position.<br />
8. Engage axle lock.<br />
9. Lower saw to just above ground.<br />
10. Lower stabilizer until distance from bottom of skid shoe to bottom of saw bits equals desired trench<br />
depth.<br />
11. Ensure that saw is aligned with planned trench and that tracks are pointing straight ahead. Work slowly<br />
and carefully.<br />
CMW