RT120Q Operator's Manual - Ditch Witch
RT120Q Operator's Manual - Ditch Witch
RT120Q Operator's Manual - Ditch Witch
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Service - 184<br />
<strong>RT120Q</strong> Operator’s <strong>Manual</strong><br />
As Needed<br />
To install chain:<br />
1. Lay chain on ground with teeth down and pointed toward unit.<br />
2. Fasten and adjust seat belt.<br />
3. Start tractor. See page 76 for start-up procedures.<br />
4. Disengage parking brake and verify parking brake indicator is off.<br />
5. Move ground drive control to reverse.<br />
6. Back unit up until chain extends past head shaft about 1’ (305 mm).<br />
7. Move ground drive control to neutral.<br />
8. Lower backfill blade, if equipped, to ground.<br />
9. Lower boom to horizontal position.<br />
10. Engage parking brake and verify parking brake indicator is on.<br />
11. Turn ignition switch to STOP.<br />
12. Pull rear end of chain over and about 10" (260 mm) past tail roller.<br />
13. Use hoist to pull front end of chain over head shaft sprocket.<br />
14. Move chain down boom until chain connector pin and lock key can be installed. Install connector pin<br />
and lock key.<br />
15. Tighten chain by pumping EPG into grease cylinder.<br />
Time Augers<br />
Ensure that augers are balanced, as shown. If<br />
auger timing is off, unit will bounce from side to<br />
side even in normal digging conditions.<br />
To adjust timing:<br />
1. Remove bolts holding augers to auger shaft<br />
and rotate either auger as needed until<br />
augers are balanced.<br />
2. Reinstall bolts and tighten securely.
Change language