DECT Telephones Comfort Pro CM 500/510 (As of ... - Telekom
DECT Telephones Comfort Pro CM 500/510 (As of ... - Telekom
DECT Telephones Comfort Pro CM 500/510 (As of ... - Telekom
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Commissioning Mobile Unit Subscription (Checking In)<br />
Mobile Unit Subscription (Checking In)<br />
Your mobile unit can be operated on a maximum <strong>of</strong> 10 different communications systems. To do so, it has to<br />
be subscribed to each system, i.e. checked in.<br />
The check-in procedure is usually done when commissioning the device. This is usually done by your system<br />
administrator for you when operated on the <strong>Comfort</strong> <strong>Pro</strong> communications system.<br />
Checking in is done via the following steps:<br />
1. Switch on the mobile unit. To do so, press the button.<br />
22<br />
When commissioning, the Language menu appears. Use the and navigation keys to select the<br />
desired display language. Confirm with the s<strong>of</strong>tkey.<br />
2. When commissioning, Subscriptions appears on the display with the New system notification.<br />
Press the Ok s<strong>of</strong>tkey to start checking in.<br />
If you do not wish to immediately start checking in, after a few seconds No system appears on the<br />
mobile unit on the idle display. In this case, press the s<strong>of</strong>tkey and call the System ><br />
Subscriptions menu.<br />
A new <strong>DECT</strong> configuration entry must be configured on the <strong>Comfort</strong> <strong>Pro</strong> communications system to<br />
check in the mobile unit. When the mobile unit is to be checked in onto the communications system using<br />
the so-called Secured procedure the IPEI (International Portable Equipment Identity) <strong>of</strong> the mobile unit is<br />
required for this configuration entry (located in the > System > Show IPEI menu).<br />
3. Enter Authentication Code: Enter the (maximum) 8-digit code which was entered into the<br />
Configurator <strong>of</strong> the communications system. If no authentication code was entered into the Configurator,<br />
no code entry is necessary. Press the Next s<strong>of</strong>tkey.<br />
N<br />
t<br />
Note: When you prefix authentication code entry with the star key, the mobile unit will<br />
be checked in as a GAP device.<br />
The length and quality <strong>of</strong> the authentication code used depends on your security<br />
requirements. Please keep in mind that the memory required for the authentication<br />
code increases 4 bits per additional digit.