[MS-ASCMD]: ActiveSync Command Reference Protocol Specification

Code Meaning Cause Scope Resolution
item. This is frequently a
transient condition.
8 The request timed out. The server took too long to
respond to the request.
Global
attempts to
synchronization fail,
consider returning to
synchronization key 0.
Retry the FolderUpdate
command.
9 Synchronization key
mismatch or invalid
synchronization key.
The client sent a malformed or
mismatched synchronization
key, or the synchronization
state is corrupted on the
server.
Global
Issue a FolderSync
command request with a
synchronization key of 0.
10 Incorrectly formatted
request.
The client sent a
FolderUpdate command
request that contains a
semantic error.
Global
Double-check the request
for accuracy.
11 An unknown error
occurred.
Unusual back-end issue. Global None.
2.2.3.152.6 Status (GetItemEstimate)
The Status element is a required child element of the Response element in GetItemEstimate
command responses that indicates the success or failure of part or all of a GetItemEstimate
command request (section 2.2.2.7.1).
Elements referenced in this section are defined in the GetItemEstimate namespace, except where
otherwise indicated by the presence of a namespace prefix (as defined in section 2.2.1).
Command
request/response
Parent
elements
Child
elements
Data type
Number
allowed
GetItemEstimate command
response (section 2.2.2.7.2)
Response
(section
2.2.3.130.2)
None
unsignedByte ([MS-
ASDTYPE] section 2.7)
1…1
(required)
If the entire request command fails, the Status element contains a value that indicates the type of
global failure. However, if the failure occurs at the Collection (section 2.2.3.28.1) level, a Status
value is returned per Collection.
The following table lists the status codes for the GetItemEstimate command (section 2.2.2.7). For
information about the scope of the status value and for status values common to all ActiveSync
commands, see section 2.2.4.
Value Meaning Cause Scope Resolution
1 Success. Server successfully completed
command.
Global
None.
2 A collection was
invalid or one of
the specified
collection IDs was
One or more of the specified
folders does not exist or an
incorrect folder was
requested.
Item
Issue a FolderSync
command (section 2.2.2.4) to
get the new hierarchy. Then
retry with a valid collection or
224 / 369
[MS-ASCMD] — v20110315
ActiveSync Command Reference Protocol Specification
Copyright © 2011 Microsoft Corporation.
Release: Tuesday, March 15, 2011