WP6-Brochure-E4 brochure - ELA European Lift Association.

More documents

Recommendations

Info

Braking (people weight>counter weight) Driving (people weightcounter weight) Braking (people weight
Figure 3‐14. Regenerative operation of a lift equipped with a regenerative inverter (source: Mitsubishi) In Figure 3‐15, possible energy savings in lifts, using different technologies, can be seen. The use of a regenerative gearless VVVF drive can reduce the consumed energy to 19%, when compared to a conventional system, using a pole changing drive (two‐speed induction motor). Figure 3‐15. Energy balance of lifts, Average energy consumption, percentage (source: Flender‐ATB‐Loher, Systemtechnik). 3.4 Permanent Magnet Motors Permanent Magnet Synchronous Motors (PMSM) are rapidly becoming the leading motor technology within the lift market in Europe. It presents many advantages, such as a simplified mechanical system for the lift, improved comfort, reduced noise and vibration, and energy savings. 27
Page 1 and 2: E4 ENERGY EFFICIENT ELEVATORS AND E
Page 3 and 4: Contents 1 Introduction ...........
Page 5 and 6: 1 Introduction Means of vertical tr
Page 7 and 8: 2 Lift and Escalator Technologies T
Page 9 and 10: Figure 2‐3. Configuration of Gear
Page 11 and 12: Some manufacturers have gone even f
Page 13 and 14: • Conventional hydraulic units do
Page 15 and 16: [2] Sachs, H., “Opportunities for
Page 17 and 18: High efficiency motors are typicall
Page 19 and 20: Figure 3‐3. Effect of load on pow
Page 21 and 22: If the linear motor is mounted on t
Page 23 and 24: 3 Phase AC input 50 Hz AC/DC Conver
Page 25: preventing the car from falling. Ty
Page 29 and 30: occupied by lift support systems. A
Page 31 and 32: Figure 3‐19. Possible configurati
Page 33 and 34: After the introduction of relay log
Page 35 and 36: It is evident that the way lifts ar
Page 37 and 38: When combined with hall call contro
Page 39 and 40: of the torque of the 1:1 roping sch
Page 41 and 42: times as quickly as a 720 mm sheave
Page 43 and 44: LEDs are also a very efficient solu
Page 45 and 46: • Car electronics • Light curta
Page 47 and 48: The major cause of energy consumpti
Page 49 and 50: 3.9 Efficient Escalators and Moving
Page 51 and 52: These bearings feature optimised in
Page 53 and 54: 4 Market Characterisation As part o
Page 55 and 56: Figure 4‐2. Lift Distribution acc
Page 57 and 58: The next three figures show the lif
Page 59 and 60: 5 Results of the Monitoring Campaig
Page 61 and 62: the lift, but does not include addi
Page 63 and 64: Where, E standby Standby Energy use
Page 65 and 66: Figure 5‐4 shows a typical cycle
Page 67 and 68: Figure 5‐6. Travel cycle consumpt
Page 69 and 70: Figure 5‐9. Measured standby powe
Page 71 and 72: Figure 5‐12. Annual Energy consum
Page 73 and 74: Figure 5‐16. Annual Energy consum
Page 75 and 76: Figure 5‐19. Annual electricity c
Page 77 and 78:
6.1.1 Determination of the average
Page 79 and 80:
Where, P mech E cycle η system h v
Page 81 and 82:
6.2. Electricity consumption of lif
Page 83 and 84:
6.3. Estimation of potential saving
Page 85 and 86:
The results show that overall savin
Page 87 and 88:
6.5. Estimation of Savings Potentia
Page 89 and 90:
Identification of stakeholders and
Page 91 and 92:
Table 7‐1. Categories of stakehol
Page 93 and 94:
esults were presented and discussed
Page 95 and 96:
We also asked which stakeholder inf
Page 97 and 98:
not rate an item. Reasons for non
Page 99 and 100:
Further barriers We asked responden
Page 101 and 102:
Raising awareness Setting a standar
Page 103 and 104:
Further topics This section address
Page 105 and 106:
The scope of the present study is o
Page 107 and 108:
Table 7‐4. Energy efficiency: Spe
Page 109 and 110:
10 Check system architecture Ropes
Page 111 and 112:
17 Avoid stalled motor door operato
Page 113 and 114:
24 Switch off other lift components
Page 115 and 116:
passenger arrives. However, an addi
show all

WP6-Brochure-E4 brochure - ELA European Lift Association.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?