You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
DRIVING<br />
BEFORE YOU START THE ENGINE<br />
Before you start the engine, make<br />
sure:<br />
1. If the tractor is properly braked.<br />
2. If the main shifting lever is in<br />
neutral position.<br />
Unless the clutch pedal is depressed, the<br />
engine cannot be started, as the start<br />
security switch is not closed.<br />
Note: Before starting of the engine it is<br />
advisable to pressurise the fuel system<br />
by several strokes of the manual feeding<br />
fuel pump.<br />
G201 P+11NG202 P+11NG203<br />
STARTING THE ENGINE<br />
1. Put the key in ignition - ”0” position.<br />
2. Depress the clutch pedal.<br />
3. Move the gear lever to the neutral position.<br />
4. Turn the key to “I“ position. The glow<br />
plug indicator illuminates.<br />
5. Wait till the glow plug indicator goes<br />
out (the time depends on the temperature<br />
of the liquid coolant).<br />
If the glow plug indicator does not<br />
illuminate but flashes, there is an<br />
error of the ignition system (Ignition<br />
system error signals chapter).<br />
Have the error repaired in a<br />
specialized service station.<br />
6. When the indicator goes out, turn the<br />
key immediately (do not wait for longer<br />
than 5 sec. at maximum) to “II“ position<br />
(start).<br />
7. After ignition, release the key immediately,<br />
it automatically turns back to ”I”<br />
position. Do not extend the starting<br />
process to more than 15s.<br />
8. After ignition, decrease the amount of<br />
fuel gradually.<br />
51
Change language