Contractors' Questionnaire - Construction Owners Association of ...

3.3 Electrical
Instructions
Please complete the following tables indicating quantity and engineering work-hours for the
categories appropriate to your project. If you cannot enter all data then enter totals only. Include
rework in the work-hours only. If the project had no work-hours or quantities for a category,
enter none.
• Total Direct Engineering Electrical Work-Hours for This Project _________
• Total Connected Horsepower of Motors _________
• Number of Motors _________
• Total KVA Load of Project _________
The quantity of electrical equipment, conduit, cable trays, wire, termination, and lighting fixtures
are the amount of each provided in the final Issued for Construction (IFC) drawings.
Refer to the section “Instructions for Computation of Work-Hours and Rework-Hours” for an
additional detailed listing of direct hours to be included and indirect hours that are to be excluded
from the computation of the work-hours.
Which design platform was used for this category in this project? Check all that apply.
2D ( )
3D ( )
Electrical Equipment
Electrical Equipment 600V & Below
None
IFC
Quantity
(each)
Engineering WH
(including rework)
(hours)
Electrical Equipment Over 600V
Electrical equipment includes transformers, switchgear, UPS systems, MCCs, rectifiers,
motors, generators, etc. This also includes work-hours for single line, elementary diagrams
and studies.
Total
Electrical Equipment
Conduit
None
IFC
Quantity
Engineering WH
(including rework)
(hours)
LM
Conduit
Number of Runs
This includes power plan, cable and conduit schedule and interconnects. Exposed /
aboveground and underground
22