pump body of PPH - Progalva
pump body of PPH - Progalva
pump body of PPH - Progalva
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ANTIFREEZE SOLUTIONS FOR AIRCONDITIONING PLANTS<br />
> Net Gel Clim Radia<br />
Description:<br />
NET GEL CLIM RADIA is an antifreezing agent on monopropylene-glycol basis and corrosion inhibitory agents,<br />
used in airconditioning circuits where a fluidification <strong>of</strong> the antifreezing agent at low temperature is necessary.<br />
Physical and chemical properties:<br />
- Red fluid.<br />
- Density 1,100.<br />
- pH-value : 8,5 – 9.<br />
- Toxic.<br />
Usage mode:<br />
According to the following table:<br />
Concentration % Density at 20˚C Protection at ˚C<br />
50 1,062 -35<br />
40 1,051 -25<br />
30 1,037 -16<br />
Determining the quantity <strong>of</strong> NET GEL CLIM RADIA to be injected:<br />
- By evaluating the capacity <strong>of</strong> the installation to be protected<br />
- By determinating the protection temperature (see table above)<br />
Cleaning the installation:<br />
- It is recommended to previously clean the installation.<br />
- If mud or oxides are present they must be removed previous to using antifreezing agents.<br />
- Even when none <strong>of</strong> the above-mentioned substances exist, a complete evacuation and rinsing before NET GEL<br />
CLIM RADIA usage is necessary.<br />
Introduction <strong>of</strong> NET GEL CLIM RADIA in the pipes by 2 methods:<br />
1 - Filling procedure: Net Gel will be introduced through the highest installation point, for many times , in order to<br />
obtain a homogenous composition.<br />
2 - A mixture <strong>of</strong> water and antifreezing agent can also be used, mixing them in a tub to have it homogenous, the<br />
mixture will then be introduced with an injection <strong>pump</strong> through an evacuation point or a valve.<br />
Quality check for the antifreezing agent mixture:<br />
- Control will be done every 2 years.<br />
- Antifreezing agent concentration: density (see above table).<br />
- Anticorrosive effect .<br />
Recommendation:<br />
The ideal dosage beginns from 30% up for a better balance between inhibitory and alkaline reserves.<br />
Reservation:<br />
Exclusive pr<strong>of</strong>essional usage. See security data sheet.<br />
Packaging:<br />
20 l and 200 l can.<br />
User recommendation:<br />
Product for pr<strong>of</strong>essional usage according to instructions. We do not assume any responsibility in case <strong>of</strong> inexpediently<br />
use <strong>of</strong> the product.<br />
6