TL-WR841N TL-WR841ND 300Mbps Wireless N Router - TP-Link

TL-WR841N/TL-WR841ND300Mbps Wireless N Router‣ Wireless Radio - Enable or disable the wireless radio choosing from the drop-down list.‣ Wireless Network Name - Enter a value of up to 32 characters. The same name ofSSID (Service Set Identification) must be assigned to all wireless devices in yournetwork. Considering your wireless network security, the default SSID is set to beTP-LINK_XXXXXX (XXXXXX indicates the last unique six numbers of each Router’sMAC address). This value is case-sensitive. For example, TEST is NOT the same astest.‣ Region - Select your region from the drop-down list. This field specifies the regionwhere the wireless function of the Router can be used. It may be illegal to use thewireless function of the Router in a region other than one of those specified in this field.If your country or region is not listed, please contact your local government agency forassistance. Note:Limited by local law regulations, version for North America does not have regionselection option.‣ Channel - This field determines which operating frequency will be used. The defaultchannel is set to Auto, so the AP will choose the best channel automatically. It is notnecessary to change the wireless channel unless you notice interference problems withanother nearby access point.‣ Mode - This field determines the wireless mode which the Router works on.‣ Channel Width - Select any channel width from the drop-down list. The default settingis automatic, which can adjust the channel width for your clients automatically.‣ Max Tx Rate - You can limit the maximum transmission rate of the Router through thisfield.‣ Disable Security - The wireless security function can be enabled or disabled. Ifdisabled, the wireless stations will be able to connect the Router without encryption. It isrecommended strongly that you choose one of following options to enable security.‣ WPA-PSK/WPA2-PSK - Select WPA based on pre-shared passphrase.• PSK Password - You can enter ASCII or Hexadecimal characters.For ASCII, the key can be made up of any numbers 0 to 9 and any letters A to Z, thelength should be between 8 and 63 characters.For Hexadecimal, the key can be made up of any numbers 0 to 9 and letters A to F,the length should be between 8 and 64 characters.Please also note the key is case sensitive, this means that upper and lower casekeys will affect the outcome. It would also be a good idea to write down the key andall related wireless security settings.- 16 -