TL-WR841N TL-WR841ND 300Mbps Wireless N Router - TP-Link

TL-WR841N/TL-WR841ND300Mbps Wireless N Router Note:1) New firmware versions are posted at http://www.tp-link.com and can be downloaded for free.There is no need to upgrade the firmware unless the new firmware has a new feature you wantto use. However, when experiencing problems caused by the Router rather than theconfiguration, you can try to upgrade the firmware.2) When you upgrade the Router's firmware, you may lose its current configurations, so beforeupgrading the firmware please write down some of your customized settings to avoid losingimportant settings.3) Do not turn off the Router or press the Reset button while the firmware is being upgraded,otherwise, the Router may be damaged.4) The Router will reboot after the upgrading has been finished.4.16.4 Factory DefaultsChoose menu “System Tools → Factory Defaults”, and you can restore the configurations ofthe Router to factory defaults on the following screenFigure 4-76 Restore Factory DefaultClick the Restore button to reset all configuration settings to their default values.• The default User Name: admin• The default Password: admin• The default IP Address: 192.168.0.1• The default Subnet Mask: 255.255.255.0 Note:Any settings you have saved will be lost when the default settings are restored.4.16.5 Backup & RestoreChoose menu “System Tools → Backup & Restore”, you can save the current configuration ofthe Router as a backup file and restore the configuration via a backup file as shown in Figure4-77.- 89 -