User Guide: ekspert™ nanoLC 400 Systems Operator ... - Eksigent

System Overview3This section provides an overview of the basic operations of the Eksigent ekspert nanoLC 400system. It is written for standard nanoLC 415 and 425 systems. Some sections describe featureswhich may not be included in the nanoLC 415 system.For information on the cHiPLC ® system, refer to the cHiPLC ® System Operator Guide.Note: Prior to completing any procedures in this section, review the Regulatory andSafety Information.Turn On the SystemCaution: Potential System Damage: If any component of the system is unplugged fromthe AC mains, make sure that the power switch on the back of the component is in the “0”position prior to connecting the component to AC mains. Failure to do so could result incomponent damage.1. If required, connect the system to the AC mains using the provided power supply.Figure 3-1Back Panel—Pump I/O Switch in Off Position2. Turn on the nanoLC 400 pump using the I/O switch on the back panel.The green LED on the front of the system illuminates.3. Turn on the autosampler using the I/O switch on the back panel.Operator Guideekspert nanoLC 400 SystemsD5033460 C 17 of 174