User Guide: ekspert™ nanoLC 400 Systems Operator ... - Eksigent

lRegulatory and Safety Information1About this GuideThis guide is intended for laboratory technicians who are responsible for day-to-day operationand maintenance of an Eksigent ekspert nanoLC 400 system. It is assumed that the user ofthis guide is familiar with standard laboratory terminology.Note: Read these safety instructions and the rest of this guide before using thesystem.Symbols and ConventionsThe following conventions are used throughout the guide.Table 1-1PictorialCaution:Symbols and ConventionsDescriptionThe danger sign warns about a hazard. It calls attention to a procedure orpractice which, if not adhered to, could results in injury or loss of life.Do not proceed beyond a danger sign until the indicated conditions are fullyunderstood and met.The warning sign denotes a hazard. It calls attention to a procedure or practicewhich, if not adhered to, could result in severe injury or damage or destructionof parts or all of the equipment.Do not proceed beyond a warning sign until the indicated conditions are fullyunderstood and met.The caution signal word denotes a hazard. It calls attention to a procedure orpractice which, if not adhered to, could result in damage or destruction of partsor all of the equipment.Do not proceed beyond a caution sign until the indicated conditions are fullyunderstood and met.The tip sign signals relevant information. Read this information, as it might behelpful.The note sign signals additional information. It provides advice or a suggestionto support equipment use.This symbol indicates that the waste of electrical and electronic equipmentmust not be disposed as unsorted municipal waste and must be collectedseparately. Please contact an AB SCIEX field service employee forinformation concerning the decommissioning of equipment.Operator Guideekspert nanoLC 400 SystemsD5033460 C 9 of 174