StreamPro ADCP Operation Manual - global site

StreamPro ADCP Operation Manual>WPA>WPA ERR 002: NUMBER EXPECTED[Your input][StreamPro response]>After correctly entering all the commands for your application, you wouldsend the CS-command to begin the data collection cycle.9.1.2 Data Output ProcessingAfter the StreamPro completes a data collection cycle, it sends a block ofdata called a data ensemble. A data ensemble consists of the data collectedand averaged during the ensemble interval. A data ensemble can containheader, leader, velocity, correlation magnitude, echo intensity, and percentgood.StreamPro output data can be in either hexadecimal-ASCII (Hex-ASCII) orbinary format. The Hex-ASCII mode is useful when you use a terminal tocommunicate with, and view data from the StreamPro. The binary mode isuseful for high-speed communication with a computer program. You wouldnot use the binary mode to view data on a terminal because the terminalcould interpret some binary data as control codes.NOTE. All of Teledyne RD Instruments’ software supports binary PD0Output Data Format only.When data collection begins, the StreamPro uses the settings last entered(user settings) or the factory-default settings. The same settings are usedfor the entire deployment.The StreamPro automatically stores the last set of commands used in RAM.The StreamPro will continue to be configured from RAM until it receives aCR-command or until the RAM loses its backup power. If the StreamProreceives a CR0 it will load into RAM the command set you last stored innon-volatile memory (semi-permanent user settings) through the CKcommand.If the StreamPro receives a CR1, it will load into RAM the factorydefault command set stored in ROM (permanent or factory settings).P/N 95B-6003-00 (February 2008) page 35