StreamPro ADCP Operation Manual - global site

StreamPro ADCP Operation Manualk. Click the X button to exit WinCEFlash (see Figure 19). Make sure toclick the X, not the white circle with the X (this only minimizes the program).If WinCEFlash is not exited, the COM port will be still in useand not available for use with the StreamPro software.Click this Xto exit!Figure 19.Exiting the WinCEFlash Programl. Re-connect the transducer cable to the electronics housing.m. Start the StreamPro program and test the communications between theiPAQ and StreamPro ADCP. If you have problems, do a soft reset onthe iPAQ and try again.P/N 95B-6003-00 (February 2008) page 39