StreamPro ADCP Operation Manual - global site

StreamPro ADCP Operation ManualTable 6:SettingEX10xxxEX11xxxEXxx1xxEXxxx1xEXxxxx1Coordinate Transformation Processing Flags (continued)DescriptionN/ANOTE. Each StreamPro uses its own beam calibration matrix to correctdata for beam pointing errors (e.g., if the beams erroneously point toward21 degrees instead of 20 degrees). Correction is applied when the dataare converted from beam coordinates to instrument coordinates. If yououtput beam-coordinate data, you will need to apply the beam correctionsyourself if you want the best possible data.EZ - Sensor SourcePurpose Selects the source of environmental sensor data.Format EZcdhprstDefault EZ1xxxxx1 (where x = 0 or 1)Recommended Setting. The default setting for this command isrecommended for most applications.RangeDescriptionFirmware switches (see description)Setting the EZ-command firmware switches tells the ADCP touse data from a manual setting or from an associated sensor.When a switch value is non-zero, the ADCP overrides themanual E-command setting and uses data from the appropriatesensor. If no sensor is available, the ADCP defaults to themanual E-command setting. The following table shows howto interpret the sensor source switch settings.Table 7: Sensor Source Switch SettingsField Value = 0 Value = 1c Speed Of Sound Manual EC Calculate using ED, ES, and ETd Depth Manual ED Manual EDh N/A N/A N/Ap N/A N/A N/Ar N/A N/A N/As Salinity Manual ES Manual ESt Temperature Manual ET Internal Transducer SensorP/N 95B-6003-00 (February 2008) page 49