User ManUal - FlowVision GmbH

FC100-CA | Flow MeterTechnical DataGMBH7.3 Analogue outputsThe analogue outputs are galvanically isolated from the electronic control unit FC100-CA.Connector pin assignment for analogue outputs V1, V2 and C1:Signal namePin XAONC 1analogue output 1 - flow 2reference ground 1 3shield 1 * 4shield 2 * 5analogue output 2 - temperature 6reference ground 2 7NC 8NC - not usedAnalogue output 1 - ANA OUT FLOW (flow output)Analogue output 2 - ANA OUT TEMP (temperature output)* Shield ungrounded - apply on one side onlyThe output is reverse polarity protected.Insulation voltage: analogue output - central electronic unit DC 500 V63