Altistart 22 - Schneider Electric

Advanced IO menu (IO)Code Name/Description R/W Adjustment range Factory settingIO (1)Advanced IO menu (continued)r1 M Relay 1 R/W* nStPUNINTENDED EQUIPMENT OPERATIONDANGERIt is mandatory that:- One of the relay (R1 or R2) must be set to trIP.- Relay R1 or R2 set to trip must be wired in order to command a line contactor as shown on page 38 through 41.Failure to follow these instructions will result in death or serious injury.StPdnStPStrtrUnrdYtrIpALrv stopped - Relay is energized at stopv not stopped - Relay is not energized at stop and is energized at all other timesv starting - Relay is energized during the start process until the bypass contactor is closedv running - Relay is energized when the bypass contactor is closedv ready - Relay is energized when the soft starter is ready to be started (mains is connected, no trip andthe maximum number of starts (Snb) is not reached)v trip - Relay is de-energized in case of tripv alarm - Relay is de-energized upon alarm, Overload alarm: thermal state of overload protection is above110%.Note: An alarm indicates the presence of non critical event.r2 M Relay 2 R/W* trIPSame as r1.FAn M Fan management R/W AUtoAUtoOnoFFHAndv auto: the soft starter manages automatically the fan.v on: always onv off: always oFFv Hand: manual Fan is controlled by a Logic input (LI2 or LI3)CAUTIONRISK OF DAMAGE TO THE SOFT STARTERWhen FAn is set to oFF or HAnd, ensure that the soft starter mets the mounting recommendations describedpage 18.Failure to follow these instructions can result in equipment damage.(1)Only available when Advanced mode LAC page 50 is set to On.*: Write only when the soft starter is stoppedBBV51330 08/2012 61