Altistart 22 - Schneider Electric

Parameter Index and Modbus addressesCode Page Name UnitModbuscode andAdjustmentRange (1)DescriptionModbusaddressFactorysettingUsersettingFor 62 Modbus format -0 = 8o11 = 8E12 = 8n13 = 8n28 bit, odd parity, 1 stop bit8 bit, even parity, 1 stop bit8 bit, no parity, 1 stop bit8 bit, no parity, 2 stop bit82 8E1Freq* Frequency Hz - - 265 -Grdd 57Grdt 57IcL 50Ground leakagecurrentthresholdGround leakagecurrent timedelaySoft starterrated current%ofIn10 to 100101 = oFFIG* Integral gain % 0 to 100%ILt 51 Current limitILt2 55 2nd current limitIn 50In2 55ItH 59Motor ratedcurrent2nd motor ratedCurrentOverloadprotection-Off5425 for S6and S6UOFF for Qs 1 to 60 - 55 5A - - 0%ofIn%ofInLAC 50 Advanced mode -200 to 700%max. value:350% of IcL200 to 700%max. value:350% of IcLThis parameter is reserved forexpert mode.Active when SSC = OnRead fromthe powercard’s serialEEPROM38 20- 17 350- 41 350A 0.4 IcL to IcL - 3A 0.4 IcL to IcL - 44-0 = oFF1 = rUn2 = On0 = oFF1 = OnLCr1 47 LCr1 Phase 1 Current, Amp 257LCr2 47 LCr2 Phase 2 Current, Amp 258LCr3 47 LCr3 Phase 3 Current, Amp 259LED*LEDS Statusoffrunonoffond4: COMM LED (0=OFF,1=ON)d6: Ready LED (0=OFF,1=ON)d7: Run LED (0=OFF,1=ON). Flashing during soft start/ soft stop.d8: Trip LED (0=OFF,1=ON)Note: other bits are reserved.According tothe softstarter ratingAccording tothe softstarter rating63 On5 oFFLFt 63 Last trip - same as dEF1 to dEF9 279 -269(1) Modbus code = Soft starter messageexample : oFF on the soft starter will be equivalent to "0" with Modbus protocol (remote command)* : parameter visible only with Modbus78 BBV51330 08/2012