12.07.2015 Views

Owner's Manual - Hearth & Home Technologies

Owner's Manual - Hearth & Home Technologies

Owner's Manual - Hearth & Home Technologies

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Read this manual before installing or operating this appliance.Please retain this owner’s manual for future reference.CongratulationsCongratulations on selecting a Heat & Glo gas appliance—an elegant and clean alternative to wood burningappliances. The Heat & Glo gas appliance you haveselected is designed to provide the utmost in safety,reliability, and effi ciency.As the owner of a new appliance, you’ll want to read andcarefully follow all of the instructions contained in thisOwner’s <strong>Manual</strong>. Pay special attention to all Cautions andWarnings.This Owner’s <strong>Manual</strong> should be retained for futurereference. We suggest that you keep it with your otherimportant documents and product manuals.The information contained in this Owner’s <strong>Manual</strong>, unlessnoted otherwise, applies to all models and gas controlsystems.Your new Heat & Glo gas appliance will give you years ofdurable use and trouble-free enjoyment. Welcome to theHeat & Glo family of appliance products!<strong>Home</strong>owner Reference InformationWe recommend that you record the following pertinentinformation about your appliance.Model Name: ___________________________________________ Date purchased/installed: __________________Serial Number: __________________________________________ Location on appliance: ____________________Dealership purchased from: _______________________________ Dealer Phone: __________________________Notes: ____________________________________________________________________________________________________________________________________________________________________________________Listing Label Information/LocationThe model information regarding your specifi c appliance can be found onthe rating plate usually located in the control area of the appliance.Test Lab & Report No.Tested andBeavertonListed byOregon USACOMNI- Test Laboratories, Inc.SERIALNO. 007Serial No.Report No. / Rapport Numero800 West Jefferson Street061-S-63-5Lake City, MN 55041www.heatnglo.comMODEL: PALOMAVENTED GAS APPLIANCENOT FOR USE WITH SOLID FUELFAN TYPE VENTED CIRCULATOR Blower Electrical Rating115 V., 1.5 Amps, 60 Hz, 150 WattsP.4.1-02 Canada Minimum Pipe 69% NG / 71% LPAPPROVED FOR CANADA AND USA TO:ANSI Z21.88b-2003 / CSA 2.33b-2003 Vented Gas Fireplace Heater, and applicable sections of UL307b Gas BurningHeating Appliances for Manufactured <strong>Home</strong>s and Recreational Vehicles, CAN/CG A 2.17-M91 “Gas Fired Appliancesfor use at High Altitudes.”This appliance is manufactured for operation with Natural Gas. For conversion to propane the Manufacturer’s kitprovided with the stove must be used in conjuntion with the instructions in the owner's manual.This vented gas fireplace heater is not for use with air filters.This appliance may be installed in a bedroom or bedsitting room; in Canada remote thermostat installation isrequired.For use with Natural Gas For use with Propane"0-2000’ "0-2000’Input Rate on “HI” (BTU/Hr) 30,000 28,000Input Rate on “LO” (BTU/Hr) 22,500 22,650Main Burner Orifice (DMS) 36 52Minimum Inlet Pressure (Inches W.C.) 4.5” 11”Maximum Inlet Pressure (Inches W.C.) 7.0” 14”Manifold Pressure on “HI” (Inches W.C.) 3.5” 10”Efficiency up to 82.5% 81%AFUE 71% 72.5%This appliance equipped for altitudes 0-2000’ (0-610m) in USA; and in Canada for altitudes of 0-4500’ (0-1370m). In USA forAltitudes above 2000’, the vent configuration, orifice, or combination of both may need to be changed. See Owner’s <strong>Manual</strong> forinformation on making these changes.This appliance must be installed in accordance with local codes, if any (and Commonwealth of Massachusetts approved); ifnone, follow The National Fuel Gas Code,ANSI Z223.1 and NFPA 54; or Canadian Installation Codes CAN/CGA-B149.NOTE: Have the gas supply line installed in accordance with local building codes by a qualified installer approved and/orlicensed as required by the locality. (In the Commonwealth of Massachusetts, installation must be performed by a licensedplumber or gas fitter.)SAMPLEMINIMUM CLEARANCES TO COMBUSTIBLESModel NameManufactured by:DO NOT REMOVE THIS LABELMADE IN U.S.A.Date of Manufacture / Date du Manufacturier2005 2006 2007 Jan Feb Mar Apr May Jun Jul Aug Sep Oct Nov DecManufactured Date2Heat & Glo • Paloma • 7031-220 Rev. S • 8/09

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!