Owner's Manual - Hearth & Home Technologies

H. Installing the BaffleThe baffle is shipped wrapped, inside the firebox. Installthe baffle with the embedded “T” side up, place it on topof the brackets on the inside of the firebox, ensuring backedge of baffle makes contact with the back of the firebox.Place log #1 into the cradle in the burner. Lean the logback towards right corner of firebox.Figure 8.17I. Positioning the LogsRemove the ignitor shield from the pilot assembly prior toinstalling the logs. (Figure 8.18).Figure 8.19Locate log #2 over the pin in log #1 and into notch in log#1. Lean the log back toward the left corner of the firebox.PILOT ASSEMBLYIGNITER SHIELDFigure 8.18While still breakable, the logs do not become fragile untilafter the appliance is burned and they have cured. Aftercuring, any handling must be done with care as breakagecan easily occur.Note: Logs have been designed to work specifi cally with theburner of this appliance. Exact placement will ensure properoperation of your gas appliance.PINFigure 8.20Heat & Glo • Paloma • 7031-220 Rev. S • 8/09 37