Owner's Manual - Hearth & Home Technologies

VALVE13. Place the round LP label on the bottom base pan.Place the propane conversion plate adjacent to theexisting rating plate.Figure 6.2RUBBERGASKETREGULATOR11. Using a 3/8 in. (10 mm) nut driver or wrench, removethe NG orifi ce and replace it with the LP orifi ce providedin this kit (see Figure 6.3).Note: The qualifi ed service agency installing this conversionMUST enter the day, month, and year, and sign the propaneconversion plate added to the appliance.14. Reinstall the bottom plate and valve assembly intothe appliance. Reinstall the six hold down screws.15. Reconnect the inlet gas line to the valve assemblyand turn on the gas line valve. Check the incomingline for leaks.16. Reconnect the electrical power supply.17. Reconnect the orange wire to the valve assembly.This will allow for the pilot to turn on with the controlswitch in the "ON" position. Check all pilot line connectionsfor leaks. (See Figure 6.4)18. Use a commercially available, non-corrosive leakcheck solution to test for leaks around the pilot. Besure to rinse off all leak check solution following testing.See Figure 6.4 for leak check points. Extinguishthe pilot.WARNINGShock or burn risk.• Disconnect green wire from gas valve.Failure to disconnect green wire could resultin severe burns.Figure 6.312. Unscrew the pilot tube fi tting on the pilot and replacethe orifi ce spud with the one included in the conversionkit (see Figure 6.4).19. Reinstall the green wire on the valve.20. Before reinstalling the burner, ensure that the shuttersetting is fully open. Reattach pilot to pilot shield toburner (see Figure 6.5). Retighten the screw.REATTACHPILOT SHIELDORIFICE SPUDFigure 6.5PILOT TUBEASSEMBLYFigure 6.4Heat & Glo • Paloma • 7031-220 Rev. S • 8/09 27