Owner's Manual - Hearth & Home Technologies

8Appliance SetupA. Remove Shipping MaterialsRemove shipping materials from inside or underneath thefi rebox.Do not remove the ignitor shield on the pilot assemblyuntil set up is complete. (Figure 8.1)B. Unbolting Appliance from the PalletThe appliance is bolted and screwed to the pallet for shipping.Use a 1/2 in. socket to remove the bolt in center ofbottom plate. Use a Phillips screwdriver to remove the twoscrews in the front of the bottom plate and the two screwsholding the metal strap across the back of the appliance.Refer to Figure 8.3 for locations.PILOT ASSEMBLYIGNITER SHIELDFigure 8.1Gas line and power cord are shipped inside back panel.To access the gas line and power cord, remove the topplate from the appliance. Remove and retain the twoAllen head screws that hold the back panel in place. Referto Figure 8.6, page 33.Using the black grommet located in the component bag,slide it into the bottom of the back panel and feed the powercord through the grommet, as shown in Figure 8.2.Figure 8.3Figure 8.2Heat & Glo • Paloma • 7031-220 Rev. S • 8/09 33