Owner's Manual - Hearth & Home Technologies

E. Top to Rear Vent ConversionNote: When installing this appliance in a rear vent confi gurationwith no vertical rise, a Snorkel Kit must be used.Kit Contents: Top cover (no hole); Back panel (with hole).Tools Required: Power drill; #2 Phillips bit; 5/32 in. (4 mm)Allen wrench; 5/8 in. (16 mm) open end wrench; high-tempsilicone sealant (optional).1. Remove the front door assembly by lifting it off of thespring-loaded latches on top of the appliance. Removethe inner glass door by disengaging the spring-loadedlatches at the bottom of the appliance and lifting it offof the two spring loaded latches at the top of the appliance.2. Remove the top plate with hole and discard. (Figure 8.8).Figure 8.10INNER EXTENSION COLLARDV ADAPTER6. Remove the four screws from the cover plate on rearof appliance. Retain screws. (see Figure 8.11).Figure 8.83. Remove and retain the Allen head screws that hold thesolid back panel in place. (Figure 8.9) Remove anddiscard the solid back panel.PILOT ASSEMBLYFigure 8.117. Install the outer collar with gasket to the rear of appliancewith screws previously removed. Install the innerextension starter collar. (Figure 8.12).8. Install the new back panel (with hole) to the rear ofappliance. Replace the allen head screws removed inStep 3 to hold the back panel in place. (Figure 8.12).Figure 8.94. Remove the four screws from the DV adapter collar.(Figure 8.10) Set aside DV adapter collar and screws.5. Remove the inner extension starter collar (Shown inFigure 8.10) and set aside.Figure 8.12Heat & Glo • Paloma • 7031-220 Rev. S • 8/09 35