Configuration and User Guide - Tyco Security Products

Web ConfigurationProcedure 3-15 Changing the Camera Address on the Live Video pageA camera address should only be changed to clear data (e.g. presets and patterns) from the baseIO flash memory, or if a new SDU8 needs to be uploaded with data from the original base IO flashmemory.CautionThe camera address needs to be changed both on the SDU8 itself and on the web GUI, via theLive Video page for camera control to be maintained.To change the SDU8 address, refer to SpeedDome ® Ultra 8 Camera Dome Operator’s Guide,8200-0600-01.1 Ensure that the browser is displaying the Configuration page (if not refer to Procedure 3-11).2 From within the Video Inputs section select the Edit button.The Video Input 1 Detail page is displayed, as shown in Figure 3-11.3 Under Camera Control Configuration, type the new address in the Camera Address text box;the range is from 0 - 254.4 Select Done to return to the Main Configuration page.5 Once the required changes have been made to the IPSDU8 configuration select Save Configto ensure all changes have been saved. Refer to Procedure 3-18 for more information onsaving configuration changes.Event Input ConfigurationThe Event Input feature is used to set triggers on the IPSDU8 which are activated by a change instate of the attached device. An example of an Event Input could be the use of a door sensor,which, when the door is opened, triggers an event on the IPSDU8 which in turn can be monitoredby the Intellex IP or VideoEdge NVR to start recording on the associated video input at a higherrate.There is only one Event Input that goes through the IPSDU8 and can be configured with the WebConfiguration tool. Three other Event Inputs are wired directly to the SDU8, and should beconfigured via the Live Video. For more information refer to the Operator’s Guide 8200-0600-01.Procedure 3-16 Configuring the Event Inputs1 Ensure that the browser is displaying the Configuration page (if not refer to Procedure 3-11).2 Select the Edit button, from within the Event Inputs section, to configure the Event Input.The Event Input Detail page is displayed, as shown in Figure 3-12.3-17