Flexicom cx combination boiler - installation and service manual

13 Servicing13.5 Condense Trap and Siphonic DrainThe condense trap and siphonic drain does not normally needservicing unless material deposits exceed beyond the servicefill level, see diagram 13.13.To clean the condense trap remove the sump and rinse withwater.13.6 Casing panel seal checkNOTE: If the functional checks did not indicate poorcombustion then it is not necessary to service thiscomponent.Check the condition of the seal and replace if worn ordamaged.To replace remove the old seal and thoroughly clean thecasing surfaces. Fit the new seals, these are supplied to thecorrect lengths and are in four pieces, for use on the sides,top and bottom.13.7 Service CompletionRe-check the combustion as described at the beginning ofthis section.On completion of the service the “Benchmark” Service Recordshould be completed.SECURINGNUTS (6)FAN CLAMPINGBRACKETBURNER14410 14397Diagram 13.1213929SUMPSECURINGSCREWCONDENSE TRAPAND SIPHONIC DRAINSERVICEFILL LEVELDiagram 13.1346