BRC Series System Guide - Sony

5Switches 5-7 (Camera address selector)Set the address of the camera. Normally set to“0”. With this setting, addresses are assigned tothe cameras automatically in the connectedorder by pressing the POWER button whileholding down the RESET button on theRM-BR300 Remote Control Unit. You can assignthe camera address “1” to “7” manually bysetting these selectors as follows:5.1.4 BRC-300/300PRear1 2 3 467Camera0 1 2 3 4 5 6 7addressSwitch 5 OFF ON OFF ON OFF ON OFF ONSwitch 6 OFF OFF ON ON OFF OFF ON ONSwitch 7 OFF OFF OFF OFF ON ON ON ONSwitch 4 is not used.Switch 8 (Infrared signal output switch)Set to ON to enable an infrared signal output,or OFF to disable the output.Switches 9, 10These switches are not used.NotePlease note that the same camera addresscannot be assigned to two or more differentcameras. Furthermore, you must set the switchesbefore you turn on camera power.1 75 Ω termination switchThis switch is used when an external sync signalis utilized. Set it to OFF when this camera is inthe middle of a daisy-chain connection ofmultiple cameras. Set it to ON when thecamera is at the end of a daisy-chainconnection.2OFFEXT SYNC IN751 2 3ONIR SELECTVIDEO5 6RS VIDEO1 2 3 4 5 6 7 8 9VISCA RS-422IN VISCA RS-232C OUTIR SELECT switchSelects the camera number when you operatemultiple cameras with the same IR RemoteCommander Unit.!DC IN12V7 8 9 10 113456789Remote sensorThis is the sensor for the supplied IR RemoteCommander Unit.VISCA RS-422 connectorEXT SYNC IN connectorVIDEO connector (Composite out)S-VIDEO connectorVISCA RS-232C IN connectorConnects to the RM-BR300 Remote Control Unit.When you join multiple cameras, connect it tothe VISCA RS-232C OUT connector of theprevious camera in the daisy chain.VISCA RS-232C OUT connectorWhen you join multiple cameras, connect it tothe VISCA RS-232C IN connector of the nextcamera in the daisy chain.1011DC IN 12V connectorCard slotLocation and Function of Parts17