Installation Manual - Panasonic

More documents

Recommendations

Info

For users in Finland, Norway and Sweden only• This unit may only be installed in a room or space with restricted access, and equipotentialbonding must be applied. For information on earthing, refer to "2.2.5 Connecting Frame Earth".For users in New Zealand only• This equipment shall not be set to make automatic calls to the Telecom '111' Emergency Service.• The grant of a Telepermit for any item of terminal equipment indicates only that Telecom hasaccepted that the item complies with minimum conditions for connection to its network. Itindicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.Above all, it provides no assurance that any item will work correctly in all respects with anotheritem of Telepermitted equipment of a different make or model, nor does it imply that any productis compatible with all of Telecom's network services.• This equipment is not capable, under all operating conditions, of correct operation at the higherspeeds for which it is designed. Telecom will accept no responsibility should difficulties arise insuch circumstances.• Some parameters required for compliance with Telecom's Telepermit requirements aredependent on the equipment (PBX) associated with this modem. In order to operate within thelimits for compliance with Telecom's Specifications, the associated PBX equipment shall be setto ensure that modem calls are answered between 3 and 30 seconds of receipt of ringing.• IMPORTANT NOTICEUnder power failure conditions, the connected telephones may not operate. Please ensure thata separate telephone, not dependent on local power, is available for emergency use.• APPLICABLE ONLY TO TELECOM CUSTOMERS WHO HAVE AUTOMATIC ACCESS TOOTHER CARRIERS FOR TOLL CALLSWhen calling back a number from the Caller ID list, all numbers prefixed with "0 + AREA CODE"will be automatically forwarded to your toll carrier. This includes numbers in your local callingarea. The zero + area code should either be removed when calling back local numbers, or checkwith your toll carrier that a charge will not be levied.• All persons using this device for recording telephone conversations shall comply with NewZealand law. This requires that at least one party to the conversation is to be aware that it is beingrecorded. In addition, the principles enumerated in the Privacy Act 1993 shall be complied within respect to the nature of the personal information collected, the purpose for its collection, howit is used, and what is disclosed to any other party.For users in Taiwan only• Lithium batteries can be found in the circuit boards of the main board and optional cards of thePBX.Notes• When disposing of any of the above products, all batteries must be removed. Follow theapplicable laws, regulations, and guidelines in your country/area regarding disposal ofbatteries.• When replacing a battery, use only the same battery type, or an equivalent recommendedby the battery manufacturer.NoticeRegarding removing or replacing a battery in the circuit board, consult your dealer.6 Installation Manual
WARNING• THIS UNIT MAY ONLY BE INSTALLED AND SERVICED BY QUALIFIEDSERVICE PERSONNEL.• IF DAMAGE TO THE UNIT EXPOSES ANY INTERNAL PARTS, DISCONNECTTHE POWER SUPPLY CORD IMMEDIATELY AND RETURN THE UNIT TO YOURDEALER.• UNPLUG THIS UNIT FROM THE AC OUTLET IF IT EMITS SMOKE, ANABNORMAL SMELL OR MAKES UNUSUAL NOISE. THESE CONDITIONS CANCAUSE FIRE OR ELECTRIC SHOCK. CONFIRM THAT SMOKE HAS STOPPEDAND CONTACT AN AUTHORISED PANASONIC FACTORY SERVICE CENTRE.• WHEN RELOCATING THE EQUIPMENT, FIRST DISCONNECT THE TELECOMCONNECTION BEFORE DISCONNECTING THE POWER CONNECTION. WHENTHE UNIT IS INSTALLED IN THE NEW LOCATION, RECONNECT THE POWERFIRST, AND THEN RECONNECT THE TELECOM CONNECTION.• TO PREVENT POSSIBLE FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THISPRODUCT TO RAIN OR MOISTURE.• THE POWER SUPPLY CORD IS USED AS THE MAIN DISCONNECT DEVICE.ENSURE THAT THE AC OUTLET IS LOCATED NEAR THE EQUIPMENT AND ISEASILY ACCESSIBLE.CAUTIONDANGER OF EXPLOSION EXISTS IF A BATTERY IS INCORRECTLY REPLACED. REPLACEONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE BATTERYMANUFACTURER. DISPOSE OF USED BATTERIES ACCORDING TO THEMANUFACTURER'S INSTRUCTIONS.Installation Manual 7
Page 1 and 2: Advanced Hybrid SystemInstallation
Page 3 and 4: Important NoticePrior to connection
Page 5: Precautions• Keep the unit away f
Page 9 and 10: IntroductionAbout the Installation
Page 11 and 12: How to replace the fuse: Open the f
Page 13 and 14: 3.2.1 Connection ..................
Page 15 and 16: Section 1System OutlineThis section
Page 17 and 18: 1.2 Basic System Construction1.2 Ba
Page 19 and 20: 1.3 Specifications1.3 Specification
Page 21 and 22: 1.3 Specifications1.3.3 System Capa
Page 23 and 24: Section 2InstallationThis section p
Page 25 and 26: 2.1 Before Installing4. Use 2-pair
Page 27 and 28: 2.2 Installing the Advanced Hybrid
Page 42 and 43: 2.3 Installing Optional Service Car
Page 48 and 49: 2.4 Connecting Outside (CO) Lines2.
Page 50 and 51: 2.5 Connecting ExtensionsMaximum Ca
Page 52 and 53: 2.6 Connecting Doorphones and Door
Page 54 and 55: 2.6 Connecting Doorphones and Door
Page 56 and 57:
2.7 Connecting Doorbell or Door Chi
Page 58 and 59:
2.8 Connecting PeripheralsPagerthe
Page 60 and 61:
2.8 Connecting PeripheralsRS-232C S
Page 62 and 63:
2.10 Starting the Advanced Hybrid S
Page 64 and 65:
2.10 Starting the Advanced Hybrid S
Page 66 and 67:
3.1 Installing KX-TEA308 Maintenanc
Page 68 and 69:
3.2 Connection3.2 Connection3.2.1 C
Page 70 and 71:
3.2 ConnectionWindows XP1. Connect
Page 72 and 73:
3.2 Connection3.2.3 Accessing PBX v
Page 74 and 75:
3.2 Connection74 Installation Manua
Page 76 and 77:
4.1 Troubleshooting4.1 Troubleshoot
Page 78 and 79:
4.1 Troubleshooting4.1.3 OperationP
Page 80 and 81:
4.1 Troubleshooting4.1.5 System Res
Page 82 and 83:
5.1 Revision History5.1 Revision Hi
Page 84 and 85:
IndexNumerics2-Channel Voice Messag
Page 86:
Panasonic Communications Co., Ltd.1
show all

Installation Manual - Panasonic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?