Mobrey

APPENDIX A2: FULL LIST OF FUNCTIONSParameter list and descriptionP=Parameter, D=Diagnostic Display ParameterParameter Description Min Max DefaultNo. value value Ex-FactoryP100 Sensor Gap in mm.This is a user entered parameter (optional).This value is ignored when an alternative spancalibration is caried out (i.e. method two or three). 0 1000 0.0P101 Sludge typeThe user can select from a list of sludge type to setup the span for the calibration procedure (optional).Each sludge type is associated with an attenuationfactor for each frequency. This value is ignored whenan alternative span calibration is caried out(i.e. method two or three). - - noneP102 dB Factor @ 1MHzA user alterable parameter. This is the attenuationnumber in dB/% at 1MHz. This is used for the spancalibration (method three). 0 - 0.000P103 dB Factor @ 3.3MHzA user alterable parameter. This is the attenuationnumber in dB/% at 3.3MHz.This is used for the spancalibration (method three). 0 - 0.000P120 Zero Ref @ 1MHzThis is the value in dBs (@ 1MHz) that is stored inthe control unit when a zero calibration is carried out.This value is over written each time a zero calibrationis carried out. - - 16P121 Zero Ref @ 3.3MHzThis is the value in dBs (@ 3.3MHz) that is stored inthe control unit when a zero calibration is carried out.This value is over written each time a zero calibrationis carried out. - - 16P122 Date of Zero RefThis is automatically stored by the control unit whenthe zero calibration is done. The actual date can beset-up in the ENGINEER menu (P730) - - --/--/----P123 Initial Zero Ref @ 1MHz dB’sThis is the value in dBs (@ 1MHz) that is stored inthe control unit when the initial zero calibration iscarried out.This value is compared with subsequentzero calibrations.0 must be entered to reset or clear initialzero value - - 0P124 Initial Zero Ref @ 3.3MHz dB’sThis is the value in dBs (@ 3.3MHz) that is stored inthe control unit when the initial zero calibration iscarried out.This value is compared with subsequentzero calibrations.0 must be entered to reset or clear initial33IP258